HP Series Hydro Tek Hot Water Portable 4.3@3500 #HP35005E3
HP Series – Electric, Diesel Fired
4.3gpm @ 3500psi, 250 degrees, 10hp, 208/230v, 3ph, 28amp CAT Pump, Belt Drive
The portable HP Series pressure washer delivers a balance of pressure, water flow and heat required for the fastest cleaning. A side-by-side demonstration will show that cleaning performance is determined more by the combination of water, heat, and flow, not just pressure. The HP pressure washer has a high-capacity burner to accommodate high water flow and achieves a higher temperature rise than other washers and saves valuable time and effort. To save you even more time, it features auto on/off, remote downstream soap control and adjustable pressure, giving the operator control at the spray gun and saving pump components and wear. It even has full pressure steam setting to clean faster on heavy equipment, greasy floors, dirty walls, oily steel or any grime-ridden surface.
High Heat/High Flow System
The balance of heat and flow increases your cleaning power providing consistent superior performance. Autoignition for peace of mind & ease of operation. High capacity diesel burner with higher temperature rise for faster cleaning.
SpiraLast™ Coil
The coil is a Hydro Tek manufactured SpiraLast™ heating coil. Robotically fused ½” schedule 80 steel pipe is cold rolled to protect the steel pipe from fatigue and the spiral coil is then surrounded by ceramic insulation and stainless enclosure with double-wall end caps. Check out our lifetime coil warranty.
Auto Start and Time Delay Shutdown
Operator has total control over the system from the trigger gun. This added convenience not only saves time and effort, it reduces wear and overheating of the pump and produces an energy-efficient system that outperforms the traditional manual on/off.
Stainless Steel Coil Housing, Frame and Panels
Rust-proof durable panels offer corrosion resistance and protection of your valuable investment from the harshest environments. Keeps your machine looking like new for years to come. Screw connects provide easy removal for full access to all major components and the Ultimate in serviceability.
Adjustable Temperature with Steam Setting
Front-mounted controls allow quick and easy adjustments of temperature and steam settings with higher heat than comparable washers for your toughest cleaning applications.
NEMA4 – Water Tight Control Panel
ETL certified to UL1776 Class 2, for use in wash-down area, exceeding Industry standards. Special Hydro Tek control box features easy to use controls and provides instant access to electronics. Dual voltage switch on most 230v models allows you to simply flip a switch to change to 208v power supply.
CAT Direct Drive Pump
High torque, low RPM drive - cooler, quieter, continuous duty performance. These Industrial triplex pumps outperform the competition in longevity - featuring concentrically bored & polished, graphite impregnated ceramic plungers with advanced seal design.
Diesel Fuel Tank with filtration
Heavy Duty “roto-molded” rust-free fuel tank with water separating fuel filter to protect against contaminated fuel. Extended run time (up to 5 hrs) eliminates interruptions.
Chemical Injection
Equipped with inlet soap injection combined with precision chemical metering valve and float tank to inject soap at full pressure for optimal cleaning effectiveness. Panel mounted controls enable the operator to vary the mixture of soap or other additives with ease.
Portability
HP Series comes standard with four large tires mounted on stainless axles and two lift handles.
More Standard Features
- Heavy-duty industrial motor with thermal overload protection
- Burst disc technology for operator safety
- Insulated quick connect nozzles
- 50’ of heavy-duty high-pressure hose
- Stainless adjustable pressure wand and heavy-duty trigger gun
- Panel mounted hour meter
- Heavy Duty Hose 50’, 250° Rated
- Adjustable Pressure Wand
- 4 Wheel Kit for portability
*PRICING TOO LOW TO ADVERTISE ONLINE, JUST CALL IN 855-351-9274
HP Series – Pressure Steamer HP20005E8 | |
---|---|
PRESSURE | 2000psi |
FLOW CAPACITY | 4.3gpm |
OUTLET TEMP | Adjustable up to 250°F (150°F rise) |
POWER/ENGINE | 6.5hp |
VOLTS/PHASE/AMPS | Dual rated for 208v or 230v – 1ph, 30amp |
CONTROLS/SWITCHES | Lighted on/off and lighted burner switch, thermostat, hour meter |
PUMP | Cat Pump, Oil Bath, Triplex Ceramic Plunger, Brass Head, Stainless Steel Valves |
POWER DRIVE | V Belt drive |
PRESSURE CONTROL | Adjustable pressure unloader and wand, safety relief valve, safety burst disc |
WATER SUPPLY | 3-1/2 gal. float tank |
PRESSURE HOSE | 3/8” x 50’ 4000psi Rated |
SOAP INJECTION | Inlet chemical injection, injects at full pressure |
GUN/WAND | 48” molded insulator, adj. pressure wand with quick coupler |
NOZZLE | #5.5 (15°, 40°) #4.5 (25° Steam) |
BURNER COIL | Spiralast™ robotically fused ½” sch. 80 steel pipe, cold-rolled 4 spiral, ceramic insulation |
BURNER/POWER | Oil Fired, Forced Draft, Automatic Ignition, Fuel Solenoid, Fuel Filter with Water Separator |
BURNER FUEL/CAP | Diesel fuel #1 or #2, Kerosene, Stove oil, JP8 fuel, 8-gallon capacity– 372,400 Btu input |
CONSTRUCTION | All Stainless: frame, panels, coil wrap, and double wall coil end caps |
WHEELS | 4) 13” tires installed |
NET WEIGHT/DIM | 470#, 46”x29”x39” |